Trafficmaster Vinyl Plank Flooring Installation Instructions

Leave a half an inch of space at the wall.

Trafficmaster vinyl plank flooring installation instructions.

Most luxury vinyl planks attach edge to edge and end to end with a fold and lock type of tongue and groove system. Starting at one end of the plank use one hand to hold the plank and the other hand to roll the edge into place for a tight fit. Connect the flooring planks. Lay the first plank appropriately spaced from the wall.

Place the second plank at the 45 degree angle with the overedge on top of the underedge. The installation of trafficmaster vinyl plank flooring requires acclimation for at least 48 hours in the room of installation. Start in the corner of the room and lay the first plank down with the underedge facing away of the wall insert quarter inch spacer between the wall and the planks as you install them. See my flooring install playlist.

How to install vinyl plank flooring as a beginner. Unlike self stick vinyl or glue down vinyl tiles both of which are installed with a full glue down application under the entire tile plank vinyl flooring is adhered only at the edges floating over the subfloor. Trim the short tongue edge from the first vinyl plank. The trick is to start attaching them at a 45 degree angle in the top corner and work your way down and then along the plank applying ample pressure during this process.

Allure plank and tile installation instructions 3. This will allow for subfloor contraction and expansion. The room of installation must be between 65 f 85 f 10 c 38 c before during and after installation. Lay the first course of traffic master floorboards along one wall so the grooved sides of the floorboards face the wall.

The over edge always placed on top of the under edge. Trafficmaster allure floating vinyl plank flooring can be a great vinyl floor product for bathroom or kitchen flooring when it is installed properly. One plank lies flat on the subfloor while the other plank is held at an angle and placed into the first board s receiving groove. The hvac system mustbe on and functional before during and after installation.

When securing two planks together you should angle 45 degrees the second plank into the corresponding edge. As this is a floating floor adhesive gripstripstm help to easily secure the planks to each other.